Instagram

View fullsize 240|64mm take down Gyuto from a little while ago. 1.3505 carbon steel with anodized aluminum handle parts. A relatively low weight of 241g is achieved thanks to the hollowed back of the handle.
View fullsize
View fullsize 230|58 Mono Integral Gyuto 1.3505 Carbon Steel Anodized Aluminum + Satined Brass + Ti Locking Screw 254 Gramm
View fullsize #stilllife
View fullsize Have I ever showed you the collab knife I made together with Luke from @scheepersbuilt ?... No?! Well, here you go :) It is probably obvious who made what here 😅
View fullsize Transferred the take down system to one of my integral constructions. This way I can use the same screws and end caps as always and don't have to buy super expensive 8mm titanium screws with extra length, which previously had to reach through the ent
View fullsize Damascus clad chef set from a little while ago
View fullsize
View fullsize Playing with some colors 🧪
View fullsize 205|58 Damascus Clad Gyuto Blade: ApexUltra Tungsten Carbon Steel Core + 1.2842 & 75Ni8 Damascus Cladding. Stock Material from @oxe_tools_forge_and_steel Handle: Natural PC-GF30 with satined brass and titanium locking screw. 180g
View fullsize A reduced version of the wa-take-down handle.
View fullsize Damascus/Tungsten chef set for a very nice and patient customer in the States. 255 layers of Damascus made of S700 and 75Ni8 as outer layers with ApexUltra core steel. I forged the bunka fairly thin for maximum cutting pleasure. The blade measure
View fullsize Another angle 👀
View fullsize This was perhaps the last knife I'll ever make - at least out of 1.2442 😋 With this blade I have now used up the last of my stock of this wonderful steel. Unfortunately, it is no longer available and will probably not be produced again 😩 Here some
View fullsize Brass is heavy stuff. So here is a light version of the front and end cap for the take down handle.